EasyManuals Logo

Siemens PUMA V400/M User Manual

Siemens PUMA V400/M
161 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
68 | Part 2
(2) Automatic operation
Command M-code listed below regardless of upper or lower unit selection, then quick
tool presetter will be downed or upped. Before commanding, be sure to check whether
the interference or collision are occurred or not by executing the command.
M76 ; Quick tool presetter will be upped.
M77 ; Quick tool presetter will be downed.
(3) Restrictions before commanding
In following cases, operation will not be occurred by commanding.
1) In case that down command cannot be done
- Spindle is in rotating
- Parts catcher being advanced
- There is interference between turret and quick tool presetter.
2) In case that up command cannot be done
- Spindle is in rotating
- In case that touch sensor is operated
- There is interference between turret and quick tool presetter.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens PUMA V400/M and is the answer not in the manual?

Siemens PUMA V400/M Specifications

General IconGeneral
BrandSiemens
ModelPUMA V400/M
CategoryIndustrial Equipment
LanguageEnglish

Related product manuals