138 | Part 4
3.2 Operation in Turret Service Mode
When turret service mode is active, the cycle start of machine is prohibited, The only turret
manual operation is possible.
(1) Turret clamp/unclamp operation
Press “Turret Clamp” soft key (①) then turret is clamped.
Press “Turret Unclamp” soft key (②) then turret is unclamped.
And you can check the status of input and output of PLC on the “Turret Status”
Screen(⑤)
(2) Revolving spindle fixing operation
< Valid on only tool post with cylinder which is used to fix the live tool spindle.>
Press “Rev. tool Fix” soft key(③) then the cylinder is fixed.
Press “Rev. tool Unfix” soft key (④) then the cylinder is unfixed.
And you can check the status of input and output of PLC on the “Milling Tool Status”
Screen(⑤)
(3) Turret rotation operation <Only valid on hydraulic tool post>
At first, unclamp turret and then Press the “TURRET CW” button to rotate the turret in
clockwise direction, or press the “TURRET CCW” button to rotate the turret in counter
clockwise.
To Next Page
Loading...
Need help?
General
