108 | Part 3
(4) TLM program
This function can be used in SHOP TURN and ISO.
If users want to use TLM function, must execute to 3steps for use.
▶ Step 1: Rec. Dimension step can set the distance to be measured. Demo cutting(w/o
workpiece).
▶ Step 2: Rec. Current step can set the distance for current [A] measuring. Real cutting.
▶ Step 3: Monitor step can detected load each axis. Real cutting.
**If want to change step(Step 1 → Step 2 → Step 3) automatically, can use mode change
at expert screen.
To Next Page
Loading...
