OPERATION | 31
(3) Handle feed restrictions
Regardless of front door open, axis traverse isn't restricted in handle mode. But in some
machine, in case that the front door is open, the axis traverse by handle is restricted.
1) If the front door is open and setup key is in "OFF" status,
handle feed is impossible in the machine having setup key.
2) If the front door is open and setup key is in “ON” status,
handle feed is possible.
3) C-axis can make the axis clamped according to the
machining condition such as tapping etc.
In case of C-axis high clamping, the traverse of C-axis is
restricted, but handle traverse is possible in low clamping.
To Next Page
Loading...
