Siemens PUMA V400/M - Part 3 PROGRAMMING; 1. M Function; 2. Tool Function (T Function); 3. Spindle Function (S Function)

10.4 Calibrating the tool probe. .................................................................... 72
11. Air blow (Option) ........................................................................... 73
11.1 Air blow operation ................................................................................ 73
12. SIGNAL TOWER (OPTION) ........................................................... 75
12.1 The machine status according to the light color of signal tower ........... 75
13. PARTS COUNT .............................................................................. 76
13.1 Parts count function ............................................................................. 76
14. AUTO POWER OFF(OPTION) ....................................................... 77
14.1 The sequence of auto power OFF ....................................................... 77
15. AUTO DOOR(OPTION) .................................................................. 78
15.1 Auto door operation ............................................................................. 78
16. CHIP CONVEYOR(OPTION) .......................................................... 79
16.1 Chip conveyor operation ...................................................................... 79
Part 3 PROGRAMMING .......................... 81
1. M Function ..................................................................................... 81
1.1 M Code List .......................................................................................... 81
2. Tool Function (T Function) ........................................................... 99
2.1 Tool change with T command .............................................................. 99
2.2 Tool offsets ........................................................................................ 100
3. Spindle Function (S Function) ................................................... 103
3.1 Spindle speed(S), direction of spindle rotation(M3,M4,M5) ............... 103
4. Tool Load Monitoring Function (Option) ................................... 104
4.1 Introduction ........................................................................................ 104
4.2 Basics operation ................................................................................ 105
4.3 Convenience Function ....................................................................... 116
Part 4 MAINTENANCE ......................... 121
1. Enter the final end user data (EUNA) ......................................... 121