OPERATION | 71
6) Press the <CYCLE START> key.
The automatic measuring process is started, i.e. the tool is traversed at
the measurement feedrate to the probe and back again.
The tool length is calculated and entered in the tool list. Whereby the
cutting edge position and tool radius or diameter are automatically
taken into consideration as well.
If turning tools with tool carrier that can be oriented are measured around Y using
any positions (not multiples of 90°) of the swivel axis, then it should be taken into
consideration that the turning tool is measured with the same tool position in both
axes X/Z, assuming that this is possible.
To Next Page
Loading...
