MAIN OPERATION PANEL | 7
(3) Automatic operation & Feed hold switch
This is the switch that performs the automatic operation in AUTO and MDA mode for
CNC program or holds the axis feed during automatic operation.
1) Cycle start switch
The available mode of cycle start is.
It can be used to start the automatic operation in AUTO mode
regarding CNC machining program called by operator.
The called program will be run automatically as soon as releasing
the cycle start switch during pressing it under the condition of
satisfying for automatic operation.
And this switch can be used on the TSM screen of JOG mode.
<LED state>
Light : in case of Automation Operation of CNC
Be careful that program will be activated to cycle start as soon as pressing this
button under the state of satisfying the condition for automatic operation.
Before cycle start, be sure to check the axis stroke etc. for preventing from
unexpected human accident and the machine damage.
2) CYCLE STOP switch
This switch is used to hold the axis feed temporarily during
automatic operation. When pressing this switch, the auxiliary
functions(M, S, T) during program execution will stop after its com-
pletion. And axis feed and dwell also stop. At that time, the
selection of machine data determines whether spindle and coolant
stop or not. In order to release the hold state and restart automatic
operation, press cycle start switch once.
<LED state>
Light : In case that the automatic operation stops and the
hold signal output comes out. However, in case of hold
during M,S, and T code execution, LED is ON and
then automatically OFF by the completion of motion.
To Next Page
Loading...
