Siemens PUMA VT1100/M - Jog Feed and Rapid Traverse Controls

8 | Part 1
(4) Jog feed switch
The following switches are provided for jog feed of axis in the machine.
Jog feed switch of each axis is available only in
mode.
According to the machine type, C can be possible.
Before pressing the direction button for jog operation, please
select the corresponding axis.
C can be selected according to the machine type.
In jog mode, jog feed switch can be used to the following manual axis operation.
1) Jog feed operation of each axis
2) Rapid traverse operation of each axis
3) Reference point return operation of each axis in reference point mode
(5) Rapid switch
Rapid override switch is for controlling the rapid speed.
Available mode:
Rapid speed will be set in machine data for every axis.
It is available for rapid moving using Jog switch in manual operation or
when selecting the Jog mode.
Operation is only available during pressing this button.
Manual rapid speed at the 100% of rapid override has been set to
parameter.