Siemens Reyrolle 7SR46 - Page 32

²
Close the battery cover again and fasten it by screwing the screw on the cover.
[dw_7SR46_batteryreplacement_step4, 1, --_--]
Figure 3-4
Placing the Battery Cover
²
After replacing the battery and in the absence of auxiliary power, phase current, low input current, and
without USB connection, test the relay by pressing the BAT ON/OFF key to confirm the relay functionality.
i
i
NOTE
Siemens recommends keeping the spare battery on a non-conductive surface to avoid any terminal short-
ages.
i
i
NOTE
After replacing the battery, sync the RTC time via Reydisp Evolution or through HMI.
Handling of the Device
3.1 Battery Replacement
32 Reyrolle, Operating, Manual
C53000-B7040-C103-1, Edition 10.2022