Connecting to the Relay for Setting via Reydisp Evolution
When Reydisp Evolution software is running, all available communication ports are automatically detected. On
the start page toolbar, open the submenu File and select Connect.
The Connection Manager window displays all available communication ports. With the preferred port high-
lighted, select the Properties option and ensure the baud rate and parity match that selected in the relay
settings. Select Connect to initiate the relay-PC connection.
[sc_reydisp_conn, 1, --_--]
Figure 5-1 PC COM port Selection
-
The relay settings can now be configured using the Reydisp Evolution software.
NOTE
•
In Reydisp Evolution, verify that Do not check communication connection is selected in the
Advanced properties
•
In Reydisp Evolution, ensure that the Relay Address in the Relay menu is the same as that of the Device
address for the 7SR4605-3[H/J]B20-1Ax0 variant.
5.2
Using Reydisp Evolution
5.2 Connecting to the Relay for Setting via Reydisp Evolution
Reyrolle, Operating, Manual 51
C53000-B7040-C103-1, Edition 10.2022
To Next Page
Loading...
