Info Alert Description
This alert appears when the relay is powered on in the battery mode.
This alert appears when the relay goes into sleep mode.
This alert appears when there is insufficient energy to perform the
following actions:
•
Turn on backlight
•
To operate or reset the binary outputs
This alert appears when you select to clear the fault records without
acknowledging the latest fault by resetting the flag.
This alert appears when the relay is powered with phase CT.
This alert appears when the relay is powered with auxiliary power
supply.
Parameter Edit Screen
7SR46 Argus Relay allows you to edit the parameter value in the LCD.
To edit any parameter, follow the procedure:
²
From the Relay Identifier screen, navigate to the Parameter screen.
²
In the Parameter screen, press ENTER key to display the edit screen.
²
In the Edit screen, you can edit the parameter value in the editable field.
²
Press ▲ key and ▼ key to select the valid value.
²
Press ENTER to save the parameter value.
To discard the parameter value, press the CANCEL key.
²
Press CANCEL until the Save and Restart pop-up screen is displayed.
²
Press ENTER to save the configuration in memory.
4.5.4
Using the Device Fascia
4.5 Notification Alerts
Reyrolle, Operating, Manual 47
C53000-B7040-C103-1, Edition 10.2022
To Next Page
Loading...
