Reset with Reydisp Evolution
You can reset stored indications via Reydisp Evolution in online mode.
Reset via Communication Protocol
You can initiate acknowledgment of stored indications also via communication through a connected substa-
tion automation technology system. This occurs in conformance to standards (Modbus RTU, IEC 60870-5-103)
or via configuration (mapping) of the LED Reset input signal for any protocol. Stored LEDs, output contacts,
and spontaneous fault displays are reset.
In Service Operation
6.7 Indications
64 Reyrolle, Operating, Manual
C53000-B7040-C103-1, Edition 10.2022
To Next Page
Loading...
