Siemens RUGGEDCOM RX1400 - Configuration and SIM Cards

Device Management
3.2Configuring the Device
Pin Name
8 Reserved (Do Not Connect)
9 Reserved (Do Not Connect)
For information about how to connect to the device via the serial console port, refer
to the RUGGEDCOM RX1400 CLI User Guide for the RUGGEDCOM RX1400.
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM RX1400 console and Web interfaces via the device's
IP address. The factory default IP address for the RUGGEDCOM RX1400 is https://-
192.168.0.2.
For more information about available ports, refer to "Communication Ports (Page
29)".
3.2 Configuring the Device
Once the device is installed and connected to the network, it must be configured. All
configuration management is done via the RUGGEDCOM RX1400 interface. For more
information about configuring the device, refer to the RUGGEDCOM RX1400 User
Guide associated with the installed software release.
3.3 Installing the SIM Cards
The RUGGEDCOM RX1400 supports dual micro-SIM cards for the LTE modem to pro-
vide a fail-over mechanism should one of the SIM cards lose connectivity with the
network.
To install micro-SIM cards from a regional cellular carrier, do the following:
CAUTION
Static electricity hazard – risk of damage to equipment.
Take appropriate anti-static precautions before accessing the SIM cards.
26
RUGGEDCOM RX1400
Installation Manual, 09/2019, C79000-G8976-1103-13