How to Use This System Manual S5-100U
Conventions
This system manual is organized in menu form to make it easier for you to find information. This
means the following:
• Each chapter is marked with printed tabs.
• At the front of the system manual is an overview page that lists the title of each chapter.
Following this page, you will find a table of contents.
• At the beginning of each chapter is a table of contents for that chapter. Each chapter has three
level headings that are numbered. The fourth level heading is not numbered but appears in
boldface type.
• Pages, figures, and tables are numbered separately for each chapter. On the back of the table
of contents for each chapter you will find a list of the figures and tables that appear in that
chapter.
This system manual employs the following specific structuring devices:
• Specific terms have characteristic abbreviations (e. g., programmer is PG).
Appendix A contains a list of abbreviations.
• Footnotes are marked with a raised number (e. g., “
1
”) or a raised asterisk (“ * ”). You will find
the corresponding explanations in the lower margin of the page or under a figure or table if the
footnote appears in one of these.
• Lists are designated with bullets (• as in this particular listing) or with hyphens (-).
• Cross references are indicated as follows: (see section 7.3.2). There are no references to
specific page numbers.
• Dimensions in drawings are indicated in millimeters and inches.
• Value ranges are indicated as follows: 17 to 21 or 17-21.
• Especially important information appears in framed boxes such as the following:
Warning
You will find definitions for the terms “Warning,” “Danger,” “Caution,” and “Note” in the Safety-
Related Guidelines for the User at the end of the introduction.
xiv
EWA 4NEB 812 6120-02
To Next Page
Loading...
