Technical Specifications
Address designation
(only for ET 200) 093
Supply voltage (BUS) 9 V
Current consumption approx. 150 mA
Special voltage V
S
5 V to 30 V
Digital Inputs
Rated input voltage 24 V
Galvanic isolation no
Input voltage:
“0” signal - 33 V to 5 V
“1” signal 13 V to 33 V
Input current typ. 8.5 mA
Supply voltage for
two-wire BEROs 22 V to 30 V
9-pin Subminiature D Connector
Output voltage
with 5-V supply
“0” signal max. 0.4 V
“1” signal min. 4.5 V
With special supply
voltage V
S
(5 V to 30 V)
“0” signal max. 0.4 V
“1” signal min. V
S
- 0.4 V
Output current 20 mA
(short-circuit proof)
Output frequency max. 204 kHz
Increment number
of steps max. 2
20
- 1 pulses/
job
Permissible cable length max. 50 m (165 ft.) at
50 kHz
(twisted pair cable)