Siemens S5-100U - Direct Signal Status Display STATUS VAR

S5-100U Start-up and Program Tests
Figure 4-5. “STATUS" Test Function
ontrol
ogram
Transfer data
Cycle trigger
a a a a a a a a a a a a a a a a a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a
a
STATUS
= Q 2.0 1 1
Refer to your programmer manual for information about the test function on your programmer.
4.6 Direct Signal Status Display “STATUS VAR”
This test function specifies the status of the operands (inputs, outputs, flags, data words, counters,
or timers) at the end of program processing. You can obtain information about inputs and outputs
from the process image I/O tables of the selected operands.
Figure 4-6. “STATUS VAR” Test Function
Transfer data
Cycle trigger
Control program
STATUS
VAR
Refer to your programmer manual for information about the test function on your programmer.
EWA 4NEB 812 6120-02 4-9