Siemens SENTRON PAC2200 - Description of SENTRON PAC2200 Features; Key Features Overview

PAC2200
Manual, 05/2018, L1V30415167B-02
11
Description
2
2.1
Features
The PAC2200 is a measuring device for measuring the basic electrical variables in low-
voltage power distribution. All measured variables are shown on the display of the PAC2200.
The device is capable of single-phase, two-phase, or three-phase measurement and can be
used in TN and TT networks.
The PAC2200 is mounted on a DIN rail.
The PAC2200 measuring device is available in several versions:
●
5 A device:
x / 1 A and x / 5 A current transformers can be used for current measuring.
●
65 A device:
No current transformers are required for current measuring. The device is connected directly
to the low-voltage network. Current of up to 65 A can be measured directly.
Depending on the device version, the PAC2200 measuring device has an integrated
Ethernet, RS485 or M-BUS interface.
Thanks to its large measuring voltage range, the PAC2200 measuring device can be
connected directly in any low-voltage system up to a voltage UL-L 480 V.
Measurement
● Measurement of all relevant electrical variables in an AC system.
● Acquisition of minimum and maximum values of all measured variables.
● Averaging of all measured variables directly on the device in two steps, which are
independent of each other and freely configurable (aggregation).
Counters and power demand
● Recording of active, reactive and apparent energy by means of several energy counters
● Calculation and storage of the last measuring period demand for active power and
reactive power for simple generation of load profiles using software (programmable
measuring period of between 1 and 60 min.).