Safety engineering with AS‑Interface in the SIMATIC ET 200SP, including typical circuit diagram
Function Manual, 08/2020, A5E44991382002A/RS-AB/002
5
1.1 Legal information
Using the application examples
The application examples illustrate automation task solutions with the interaction of several
components in the form of text, graphics and/or software blocks. The application examples
are a free-of-charge service provided by Siemens AG and/or a subsidiary company of Siemens
AG ("Siemens"). They are not binding and do not claim to be complete or functional with
regard to configuration or equipment. The application examples do not represent customer-
specific solutions, but rather, only provide help for typical tasks. You are responsible for the
proper and safe operation of products in compliance with the applicable regulations. You
must check the function of the associated application example and adapt it specifically to
your system.
Siemens grants you the non-exclusive, non-sub-licensable and non-transferable right of use
of the application examples by professionally trained personnel. Any change to the
application examples is made purely at your own risk. Transfer to third parties or duplication
of the application examples or extracts thereof is permitted only in combination with your
own products. The application examples do not necessarily undergo the usual tests and
quality checks of a paid product, may contain functional and performance defects and may
be subject to errors. You are fully responsible for ensuring that the application examples are
used in such a way that any potentially defective functions do not lead to property damage
which leads to injury to persons.
Disclaimer of liability
Siemens excludes any liability, irrespective of the legal ground, in particular for the use as
well as associated notes, configuration and performance data and any damage they may
cause. This shall not apply in cases of mandatory liability of Siemens, for example under the
German Product Liability Act, or in cases of intent, gross negligence or culpable breach of
material contractual obligations. The claims for compensation for the breach of essential
contractual obligations are, however, limited to the foreseeable damage typical for the type
of contract, except in the event of intent or gross negligence or death or injury or health
impairment. The above provisions do not imply a change in the burden of proof to your
detriment. You exempt Siemens from any third-party claims that may exist or arise in this
connection, unless Siemens is compulsorily liable by law.
By using the application examples, you agree that Siemens cannot be made liable for any
possible damage beyond the liability provisions described.
To Next Page
Loading...
Need help?
General
