iii
FM 351 Positioning Function Module
EWA 4NEB 720 6001-02
Preface
This manual describes all the steps that are necessary to effectively use the
FM 351 Positioning Function Module.
This manual describes the hardware and software of the FM 351 Positioning
Function Module. The manual contains the following subjects:
Principles of positioning
Installing and removing the FM 351
Wiring the FM 351
Assigning the FM 351 parameters
Programming the FM 351
Setting up the FM 351
Reference information
Appendices
For queries about the use of products described in this manual, the answers to
which you cannot find here, please consult your Siemens contact person at
the appropriate representatives and offices. You will find addresses, for ex-
ample, in the appendix “SIEMENS Worldwide” to the manual S7-300 Pro-
grammable Controller, Hardware and Installation.
With queries or comments about the manual itself, please fill in the reply slip
located at the end of the manual and return it to the stated address. Please
also enter your personal assessment in the manual reply slip.
We offer courses designed to make your introduction to the SIMATIC S7 Pro-
grammable Controller easier. To obtain information about these, please con-
tact your regional training center or the central training center in D-90027
Nuremberg, Tel. +49-911-895-3154.
This manual contains the description of the FM 351 Positioning Function
Module which is valid at the time of publication. We reserve the right to de-
scribe changes to the functional features of the FM 351 in product informa-
tion.
Our products fulfill the requirements of the EU guideline 89/336/EWG
“Electromagnetic Compatibility” and of the harmonized European standards
(EN) listed in it.
Purpose
Audience
Additional
Assistance
Scope of this
Manual
CE Labeling
To Next Page
Loading...
