5-1
FM 351 Positioning Function Module
EWA 4NEB 720 6001-02
FM 351 Parameterization
You parameterize the positioning module with the parameterization software.
The software is intended for the FM 351 and the FM 451. The description of
operation can be found in the integrated help.
Before you begin the parameterization of the FM 351 Positioning Function
Module, you should check the following requirements:
STEP 7 from V2.0 is correctly installed on your programming device/PC.
The complete software (parameterization software and function blocks) is
located on a 3.5 in. diskette. You install the software as follows:
1. Insert the diskette into the disk drive on your programming device/PC.
2. Under Windows 95 start the dialog on the installation of the software by
double clicking the symbol “Software” in “System Control”.
3. In the dialog select the disk drive and the file Setup.exe and start the
installation process.
4. Step by step follow the instructions which the installation program dis-
plays.
Result: The software is installed in the following folders:
– Function blocks: STEP7_V2\S7LIBS\FM_POS
– Example: STEP7_V2\EXAMPLES\FM_POSP
Note
If you selected a folder other than STEP7_V2 for the STEP 7 installation,
this folder is recorded.
Introduction
Requirements
Installation
5
To Next Page
Loading...
