Technical Specifications
A-2
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
FM approval
The FM approval is on record for the FM 353:
FM certification in accordance with Factory Mutual Approval Standard Class Num-
ber 3611, Class I, Division 2, Group A, B, C, D.
!
Warning
Potential for personal injury and property damage.
In areas where there is a risk of explosion, personal injury and property damage
may occur if you disconnect plugs while the S7-300 is in operation.
In areas where there is a risk of explosion, always cut off power to the S7-300 be-
fore disconnecting plugs.
!
Warning
WARNING - NEVER DISCONNECT WHILE CIRCUIT IS LIVE
UNLESS LOCATION IS KNOWN TO BE NONHAZARDOUS
CE marking
Our products are in compliance with the EU Guideline 89/336/EEC “Electromag-
netic Compatibility” and the harmonized European standards (EN) which it embo-
dies.
The EC Declaration of Conformity in accordance with Article 10 of the EU Guide-
line referenced above can be found on the Internet at:
http://support.automation.siemens.com/WW/view/de/15257461
Application
SIMATIC products are designed for application in an industrial environment.
Application Requirement concerning
Noise emission Noise immunity
Industry EN 50081-2 : 1993 EN 61000-6-2 : 1999
Observe installation guidelines
SIMATIC products meet the requirements, provided you observe the installation
guidelines set forth in the manuals during installation and operation.
To Next Page
Loading...
