Siemens SIMATIC FM 353 - Page 54

Defining Parameters
5-2
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Overview
This chapter gives you an overview of how to define the parameters of the FM 353
with the “Parameterize FM 353” tool.
P bus
K bus
MPI
CPU
FM 353
S7-300
Online (editing in the
Target system menu
and selection of the
Online editing option)
Offline (editing in the File
menu)
PG
(STEP 7)
HW-CONFIG
Parameter-
ization forms
Rack parameterization -
Group selection -
Activate interrupts
(basic parameters)
Module parameterization
Configuration: Generate system data
Data blocks (DB)
S DB-MD
S DB-SM
S DB-TO
S DB-NC
Setup.exe
User
data block
S Parameterization tool “Parameterize FM 353”
S Function blocks
S MD-DBs (for start-up of stepper motor)
1)
S Preconfigured user interface for OPs
S Manual in PDF format
S Getting Started in PDF format
1) See Getting Started and Chapter 7
Fig. 5-1 Overview of parameterization