Commissioning the device
5.4 Using the SIMATIC software with a License Key
SIMATIC IPC MD-57A
50 Operating Instructions, 09/2023, A5E52775302-AA
If you want to transfer the license key later, follow these steps:
1. Close the Automation License Manager. Locate the drive named "License_Key" in the left
pane.
2. Click the drive named "License_Key".
This displays an overview of the license keys found on the license stick.
3. Use a drag-and-drop operation to move the desired license key to one of your drives.
4. After the transfer, the license key is located on the corresponding drive and you can now use
the activated software.
Prior to removing the license stick, make sure to disconnect it according to the Windows
specifications ("Safely removing hardware").
You may also use the USB license stick to transfer the license keys to a different computer, or
to store them intermediately.
Note
Installed software for which no license key is included in the scope of delivery cannot be used
or only runs in trial mode.
To Next Page
Loading...
