SIMATIC IPC MD-57A
Operating Instructions, 09/2023, A5E52775302-AA
89
Note
Approvals on the rating plate
The following overview provides information on possible approvals.
Only the approvals printed on the rating plate apply to the device.
11.1 Certificates and approvals
The Siemens quality management system for our entire product creation process
(development, production and sales) meets the requirements of ISO 9001.
This has been certified by DQS (the German society for the certification of quality
management systems).
If the device is supplied with preinstalled software, you must observe the corresponding
license agreements.
The following approvals are available for the device:
• Underwriters Laboratories (UL) according to the standard UL 62368-1 Third Edition
(PROG.CNTLR.)
• Canadian National Standard CAN/CSA C22.2 No. 62368-1-14 Third Edition
cations Commis-
sion
Radio Frequency
Interference State-
ment
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this equipment to maintain compliance with
FCC regulations.
Changes or modifications not expressly approved by the manufacturer could void
the user’s authority to operate the equipment.
erations
This device complies with Part 15 of the FCC Rules and Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired oper-
To Next Page
Loading...
