Siemens SIMATIC IPC PX-39A PRO - Important Information

Firmware/BIOS description SIMATIC IPC BX-39A, IPC PX-39A, IPC PX-39A PRO
Operating Instructions, 01/2023, A5E51110693-AA
3
Important information
Information about this description
Basic knowledge requirements
This firmware / BIOS description is intended for the following qualified personnel:
• Programmers and testers who commission the device themselves and connect it to an
automation system.
• Service and maintenance technicians who install enhancements or conduct fault analyzes.
A solid background in personal computers is required to understand this manual. General
knowledge in the field automation control engineering is recommended.
Scope of validity
This firmware/BIOS description applies to the following SIMATIC IPCs:
• SIMATIC IPC BX-39A
• SIMATIC IPC PX-39A
• SIMATIC IPC PX-39A PRO
History
The following versions of this firmware/BIOS description have been published previously:
Edition
Comment
01/2023
First Edition
Firmware/BIOS
The firmware (BIOS) is located in a flash block on the motherboard.
The firmware selection menu can be opened after the device has been started. You can then
configure the firmware settings of your device.