Requirements for use
2.2 Software requirements
CP 1243-1 DNP3, CP 1243-1 IEC
18 Operating Instructions, 02/2014, C79000-G8976-C312-02
●
– IEC CP
– CPU with firmware version V3.0 or V4.0
– DSL router + SCALANCE S
See also the reference in the section "Notes on the DSL router" below.
● Compatible DNP3 or IEC master
● DSL router + SCALANCE S
See also the reference in the section "Notes on the DSL router" below.
● When using online functions: Engineering station with STEP 7 (see following section)
You will find the requirements for communication and the configuration options in the section
Configuration with connections over the Internet (Page 14).
Software requirements
Configuration software
To configure the modules, the following configuration tool is required:
● DNP3 CP with firmware version V1.0:
STEP 7 Basic ab V12.0 SP1
● DNP3 CP with firmware version V1.1:
STEP 7 Basic V13.0
● IEC CP with firmware version V1.1:
STEP 7 Basic V13.0
Software for online functions
STEP 7 in the version specified above
To Next Page
Loading...
