CP 1243-1 DNP3, CP 1243-1 IEC
Operating Instructions, 02/2014, C79000-G8976-C312-02
65
Current approvals on the Internet
SIMATIC NET products are regularly submitted to the relevant authorities and approval
centers for approvals relating to specific markets and applications.
You will also find the current approvals for the product on the Internet pages of Siemens
Automation Customer Support under the following entry ID:
68853485 (http://support.automation.siemens.com/WW/view/en/68853485)
→ "Entry list" tab, entry type "Certificates"
SIMATIC NET products are regularly submitted to the relevant authorities and approval
centers for approvals relating to specific markets and applications.
If you require a list of the current approvals for individual devices, consult your Siemens
contact or check the Internet pages of Siemens Automation Customer Support:
45605894 (http://support.automation.siemens.com/WW/view/en/22548697)
Under this entry, go to the relevant product and select the following settings: "Entry list" tab >
entry type "Certificates".
Note
Issued approvals on the type plate of the device
The specified approvals apply only wh
en the corresponding mark is printed on the product.
You can check which of the following approvals have been granted for your product by the
markings on the type plate.
The CP has the following approvals and meets the following standards:
EC declaration of conformity
The CP meets the requirements and safety objectives of the following EU directives and it
complies with the harmonized European standards (EN) for programmable logic controllers
which are published in the official documentation of the European Union.
To Next Page
Loading...
Need help?
General
