EasyManua.ls Logo

Siemens SIMATIC NET S7-1200 - Page 5

Siemens SIMATIC NET S7-1200
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Preface
CP 1243-1 DNP3, CP 1243-1 IEC
Operating Instructions, 02/2014, C79000-G8976-C312-02
5
Replaced documentation
This manual replaces the manual release 07/2013.
Current manual release on the Internet
You will also find the current version of this manual on the Internet pages of Siemens
Industry Online Support in the directory of the relevant CP. This is located below the
directory with the following entry ID:
16514597 (http://support.automation.siemens.com/WW/view/en/16514597)
Required experience
To install, commission and operate the CP, you require experience in the following areas:
Automation engineering
Setting up the SIMATIC S7-1200
SIMATIC STEP 7 Basic / Professional
DNP3 protocol or protocol according to IEC 60870-5
Requirements for use of the module
You will find the requirements for using the module in the section Hardware requirements
(Page 17).
Sources of information and other documentation
You will find an overview of further reading and references in the Appendix of this manual.
SIMATIC NET glossary
Explanations of many of the specialist terms used in this documentation can be found in the
SIMATIC NET glossary.
You will find the SIMATIC NET glossary here:
SIMATIC NET Manual Collection or product DVD
The DVD ships with certain SIMATIC NET products.
On the Internet under the following entry ID:
50305045 (http://support.automation.siemens.com/WW/view/en/50305045)

Table of Contents

Other manuals for Siemens SIMATIC NET S7-1200

Related product manuals