Siemens SIMATIC NET - Approvals and Certifications; Issued Approvals and Type Plate Information; Notes for Machine Manufacturers

Optical link module
Operating Instructions, 01/2020, C79000-G8976-C270-06
79
Approvals
12
The SIMATIC NET products described in these Operating Instructions have the approvals
listed below.
Note
Issued approvals on the type plate of the device
The specified approvals apply only when the corresponding mark is printed on the product.
You can c
heck which of the following approvals have been granted for your product by the
markings on the type plate.
Notes for the manufacturers of machines
The devices are not machines in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 2006/42/EC for these
devices.
If the devices are part of the equipment of a machine, they must be included into the EU
declaration of conformity procedure by the manufacturer of the machine.
Current approvals on the Internet
You will find the current approvals for the product on the Internet pages of Siemens Industry
Online Support (https://support.industry.siemens.com/cs/ww/en/ps/15273/cert
).