Siemens SIMOGEAR BA 2030 - Page 106

Technical data
10.1 Type designation
BA 2030
104 Operating Instructions, 02/2021, A5E37880173A/RS-AM
Type
Shaft
(-)
Solid shaft
A
Hollow shaft
Fixing
(-)
Foot-mounted design
B
Foot / flange-mounted version
F
Flange-mounted design (A type)
Z
Housing flange (C type)
D
Torque arm
G
Flange (A type) opposite output shaft
Connection
(-)
Parallel key
S
Shrink disk
T
Hollow shaft with splines
R
SIMOLOC assembly system
Special features
W
Reduced-backlash version
Intermediate helical gearbox - transmission stage
Z
Two-stage
D
Three-stage
Input unit
KS
Coupling adapter only for mounting a SIEMENS SIMOTICS S-1FK7/-1FT7,
SIMOTICS M-1PH8, SIMOTICS S-1FK2, SIMOTICS S-1FL6 servomotor
K2
Coupling adapter with flexible coupling for fitting an IEC motor
K3
Coupling adapter with flexible coupling for fitting a NEMA motor
K4
Short adapter with plug-in connection for fitting an IEC motor
K5
Short adapter with plug-in connection for fitting a NEMA motor
KQ(S)
Coupling adapter for mounting a SIMOTICS S-1FK7/-1FT7 servomotor
K8
Coupling adapter for mounting a SIMOTICS M-1PH8 servomotor
A
Adapter with free input shaft
Ex marking
-
No Ex version
1
Ex version