Service and maintenance
8.5 Replace bearings
BA 2030
96 Operating Instructions, 02/2021, A5E37880173A/RS-AM
Maintenance interval after regreasing
After regreasing, the maintenance interval can be increased to the following number of
operating hours.
Table 8- 9 Maintenance interval in operating hours [h] for relubrication
Output speed n
2
8.5 Replace bearings
The bearing service life is finite, greatly depends on the operating conditions and therefore
cannot be calculated reliably. In the operating conditions specified by the operator, bearing
life can be calculated. Changes in vibration and noise pattern are an indication that an
immediate bearing replacement is necessary.
To Next Page
Loading...
