Siemens SIMOGEAR BA 2030

Installation
4.9 Installing and removing the shaft-mounted gearbox
BA 2030
Operating Instructions, 02/2021, A5E37880173A/RS-AM
43
4.9.3 Hollow shaft with shrink disk
4.9.3.1 Mounting the hollow shaft with shrink disk
a
Greased
b
Absolutely grease-free
*
Not included in scope of supply
①
Machine shaft
②
Hollow shaft
③
Bushing
Figure 4-7 Mounting the hollow shaft with shrink disk
Procedure
1. Using benzine or a solvent, remove the anti-corrosion protection from the shaft ends and
flanges.
2. Check the seats or edges of the hollow and machine shafts for damage. Contact Technical
Support if you notice any damage.
3. Mount the gearbox with the shrink disk shaft onto the machine shaft. Carefully ensure the
correct position and that the shrink disk seat completely covers the machine shaft.
You have mounted the hollow shaft with shrink disk.