General information and safety notes
1.7 The five safety rules
BA 2030
Operating Instructions, 02/2021, A5E37880173A/RS-AM
15
1.7 The five safety rules
For your own personal safety and to prevent material damage when carrying out any work,
always observe the safety-relevant instructions and the following five safety rules according
to EN 50110-1 Working in a voltage-free state. Apply the five safety rules in the sequence
stated before starting work.
Five safety rules
1. Disconnect.
Also disconnect the auxiliary circuits, for example the anti-condensation heating.
2. Secure against reconnection.
3. Verify absence of operating voltage.
4. Ground and short circuit.
5. Cover or safeguard neighboring live parts.
After the work has been completed, undo the measures taken in the reverse order.
1.8 Particular types of hazards
Extreme surface temperatures
Hot surfaces over +55 °C pose a burn risk.
Cold surfaces below 0 °C pose a risk of damage due to freezing.
Do not touch the gearbox without protection.
Hot, escaping oil
Before starting any work wait until the oil has cooled down to below +30 °C.
Poisonous vapors when working with solvents
Avoid breathing in vapors when working with solvents.
Ensure adequate ventilation.
To Next Page
Loading...
