Siemens SIMOGEAR BA 2030

Technical data
10.6 Mounting positions
BA 2030
Operating Instructions, 02/2021, A5E37880173A/RS-AM
115
10.6 Mounting positions
10.6.1 General notes on mounting positions
Only operate the gearbox in the mounting position specified on the rating plate. This ensures
that the correct quantity of lubricant is provided. The symbols are shown for the standard
mounting position.
Note
Gearbox sizes 19 and 29
Gearbox sizes 19 and 29 are lubricated for life. There is no opening to check the oil level.
In mounting positions M2 and M4 th
e gearboxes are equipped with a breather valve.
C29 has a breather valve in all mounting positions.
Description of the symbols:
Venting
Oil level
Oil drain
A, B
Position of insert shaft / solid shaft
*
On opposite side
①
Oil level check not possible for tandem gearbox (main gearbox a)
②
Two-stage gearbox
③
Three-stage gearbox