Installation
4.9 Installing and removing the shaft-mounted gearbox
BA 2030
48 Operating Instructions, 02/2021, A5E37880173A/RS-AM
4.9.4 SIMOLOC assembly system
4.9.4.1 General notes for the SIMOLOC assembly system
Risk of injury due to freely rotating parts
Fit a cover cap or protection cover.
Damaged components impair the correct function of the gearbox
If any components are damaged, the correct function of the gearbox will no longer be
ensured.
Do not install any damaged gearbox components.
Lubricant on the machine shaft ① impairs the torque transmission
Keep the bore in the tapered bushing ⑨ and the machine shaft ① completely grease-free.
Do not use impure solvents and soiled cleaning cloths.
Avoid overloading the individual bolts
Do not exceed the maximum tightening torque for the tightening bolts ④ und ⑩.
The SIMOLOC assembly system secures the hollow shaft axially on the machine shaft.
⑥, oil the locating hole for the tapered bushing ⑨ and bronze bushing ②
the provided oil.
Oil type of the provided oil: CLP VG 68 DIN 51517-3
Note
The thrust collar ⑤ must be placed at the correct position as in the delivered state.
Before installing the SIMOLOC, mount the torque arms ⑦ on the gearbox.
To Next Page
Loading...
