Installation
4.9 Installing and removing the shaft-mounted gearbox
BA 2030
Operating Instructions, 02/2021, A5E37880173A/RS-AM
39
4.9 Installing and removing the shaft-mounted gearbox
4.9.1 General information on installing the shaft-mounted gearbox
Damage to shaft sealing rings caused by solvent
Avoid any contact of solvent or benzine with the shaft sealing rings.
Subjecting stress to the hollow shaft causes bearing failure
Skewing or stressing the hollow shaft increases the loading. This can cause bearing failure.
The hollow shaft must be flush with the machine shaft to avoid misalignment.
Do not subject the hollow shaft to axial and radial stress.
For shrink disks:
Lubricants in the area between the hollow shaft and machine shaft impair torque
transmission
Keep the bore in the hollow shaft and the machine shaft completely grease-free.
Do not use impure solvents and soiled cleaning cloths.
Coat the contact surfaces with the mounting paste supplied with the product or any suitable
lubricant to prevent frictional corrosion.
Observe the permissible concentricity tolerance of the
cylindrical shaft extension of the
machine shaft to the housing axle according to DIN 42955.
To Next Page
Loading...
