Installation
4.8 Removing and installing the protection cover
BA 2030
Operating Instructions, 02/2021, A5E37880173A/RS-AM
37
4.8 Removing and installing the protection cover
Sparks may be caused by a damaged protection cover. Replace damaged protection
covers immediately.
Secure bolts ① with, e.g. Loctite 243 medium-strength adhesive.
The plastic cover is not in conformance with ATEX.
The protection cover of the hollow shaft is delivered ready-fitted to the gearbox flange.
Dismantle the protection cover for installation of the output shaft.
The plastic protection cover of the hollow shaft is supplied loose as kit.
Figure 4-3 Protection cover for hollow shaft
Procedure
Premounted protection cover
1. Release the screws ① and remove the protection cover ② together with the flat gasket or O-
ring ③.
2. Mount the output shaft.
3. Use a suitable cleaning agent to clean the contact surface of the protection cover ② on the
gearbox.
4. Ensure that the flat seal or the O-ring ③ is correctly seated.
5. Wet the bolts ① with medium-strength adhesive, e.g. Loctite 243.
6. Screw on the protection cover ②.
To Next Page
Loading...
