Installation
4.7 Mounting an input or output element on the gearbox shaft
BA 2030
36 Operating Instructions, 02/2021, A5E37880173A/RS-AM
Use a fitting device to fit the input or output elements.
Figure 4-1 Example of a fitting device
Observe the correct mounting arrangement to minimize stress on shafts and bearings due to
lateral forces.
Figure 4-2 Mounting arrangement for low stress on shafts and bearings
Procedure
1. Use either benzine or solvent to remove the anti-corrosion protection from the shaft ends
and flanges or remove the applied protective skin.
2. Fit the drive input and output elements to the shafts. Fasten the elements when necessary.
You have now fitted the input or output element.
To Next Page
Loading...
