Siemens SIMOGEAR BA 2030

Service and maintenance
8.4 Lubrication of the XLplus and VLplus heavy-duty bearing systems
BA 2030
Operating Instructions, 02/2021, A5E37880173A/RS-AM
95
Rolling bearing grease
NOTICE
Impermissible mixing of rolling bearing greases results in damage
Residual quantities of original oil can impair the specific properties of the new oil.
When regreasing, do not mix greases with a different soap base.
Use the recommended rolling bearing grease when relubricating the bearings.
Using a grease gun, inject the grease into the bearing point via the lubricating nipples
provided.
The grease quantities listed in the table are guide values.
Table 8- 8 Grease quantity [g] for relubrication
Regreasing interval
Grease quantity for size
89
109
129
149
169
g
After 6 months
10
10
20
20
30
After several years without
operation
28
33
46
68
95
Maintenance of the output-side bearing
Note
Change the grease fill
ing of the rolling bearing when you change the gear oil.
Use the recommended rolling bearing grease when filling the bearings with new grease.
Procedure
1. Dismantle the output-side bearing unit.
2. Clean the bearing.
3. Fill the bearing with the new grease up to approximately 30% of the free bearing chamber.
4. Reassemble the bearing unit.