Siemens SIMOTICS HV C User Manual

4.13.11 Protection against corrosion
If the machine is stored in dry conditions, then apply the subsequently listed anti-corrosion
measures:
● Storage up to six months:
Apply a coat of corrosion protective compound to all accessible bare metal parts such as
the exposed shaft extension, flange or machine feet.
● Storage for longer than six months:
Apply a coat of long-term anti-corrosion agent to all accessible bare parts.
● Inspect the machine regularly and if necessary, apply an additional coating of corrosion
protection.
Document all preservation measures taken so that they can be reversed before the machines
are put back into service.
4.14 Converter operation
4.14.1 Tandem operation
If you connect two motors in series for "tandem operation", install an insulated coupling
between the motors; this coupling should satisfy series of standards GB 25286 or the
regulations that apply in the country where the equipment is installed.
Preparations for use
4.14 Converter operation
SIMOTICS HV C 1NB1402-2AA84-4CA0-Z
38 Operating Instructions 06/2018

Siemens SIMOTICS HV C Specifications

General

Brand	Siemens
Model	SIMOTICS HV C
Category	Engine
Language	English