Siemens SIMOTICS HV C - Default Chapter; Table of Contents

Table of contents
1 Introduction.................................................................................................................................................11
1.1 About these instructions.........................................................................................................11
1.2 Compiling personal documents..............................................................................................12
2 Safety information.......................................................................................................................................13
2.1 Information for those responsible for the plant.......................................................................13
2.2 The 5 safety rules...................................................................................................................14
2.3 Qualified personnel................................................................................................................14
2.4 Safe handling.........................................................................................................................14
2.5 Use in hazardous zones and areas........................................................................................16
2.6 Electrostatic sensitive devices...............................................................................................17
2.7 Electromagnetic compatibility.................................................................................................18
2.8 Interference immunity.............................................................................................................18
2.9 Influence on the line power supply through a strongly irregular torque..................................18
2.10 Electromagnetic fields when operating electrical power engineering installations.................18
3 Description..................................................................................................................................................19
4 Preparations for use...................................................................................................................................23
4.1 Safety-related aspects to consider when configuring the plant..............................................23
4.2 Observing the operating mode...............................................................................................23
4.3 Ensure adequate cooling.......................................................................................................23
4.4 Interlock circuit for anti-condensation heating........................................................................23
4.5 Noise emission.......................................................................................................................24
4.6 Voltage and frequency fluctuations during line operation......................................................24
4.7 Phase synchronization during supply system switching........................................................24
4.8 System-inherent frequencies.................................................................................................24
4.9 Torsional loading of the drive train due to faults in the electrical supply................................25
4.10 Switching high-voltage motors...............................................................................................25
4.11 Machines without final paint coating......................................................................................26
4.12 Thermal protection.................................................................................................................26
4.13 Transport and storage............................................................................................................27
4.13.1 Transport markings................................................................................................................27
4.13.2 Checking the delivery.............................................................................................................27
4.13.3 Attaching the rotor shipping brace.........................................................................................28
SIMOTICS HV C 1NB1402-2AA84-4CA0-Z
Operating Instructions 06/2018 5