Note
Store the rotor locking device
Be sure to store the rotor locking device. It must be remounted for possible disassembly and
transport.
5.2.6 Working on the underside of the machine
● Never remain under or in the immediate vicinity of the machine when it is lifted. If the lifting
gear or load handling attachments were to fail, the machine could fall. This can result in
death, serious injury or material damage.
● In order to gain easy and safe access to the underside of the machine, place it in a secure
and raised position.
5.2.7 Removing anti-corrosion protection
Machined, bare metal surfaces of machine parts and small components such as screws, bolts,
wedges, feather keys, and dowel pins, are treated with an anti-corrosion agent.
Carefully remove the anti-corrosion agent and immediately start the installation work.
Bright surfaces on machine parts
● Use petroleum, petroleum ether, or a similar solvent or detergent to remove the anti-
corrosion coating from the machined surfaces of machine parts and from small components.
NOTICE
Paintwork damage
Make sure that the cleaning agent or solvent does not come into contact with any painted
surfaces, as this could damage the lacquer.
● Use a suitable solvent to soften thick layers of anti-corrosion agent. Then push off the
softened layers using a piece of hardwood (approximately 10 x 10 x 1 cm). Do not sand
the protective coating down or scrape it off.
NOTICE
Do not use metal tools.
Do not use metal objects such as scrapers, spatulas, or plates to remove the anti-corrosion
protection,
as this could damage the surfaces of the machine parts.
● Lightly oil the depreserved surfaces.
Assembly
5.2 Lift the machine to where it will be installed, and position it
SIMOTICS HV C 1NB1402-2AA84-4CA0-Z
50 Operating Instructions 06/2018
To Next Page
Loading...
Need help?
General