Siemens SIMOTICS S-1FK2 User Manual

Procedure
1. Verify absence of operating voltage to the converter.
WARNING
Danger to life due to unintentional starting of the drive unit
Unintentional starting of the drive unit can cause death or severe injury.
• Make sure that the drive unit cannot be started accidentally.
• Post a warning notice to this e󹪜ect at the point where the switch is located.
2. Replace the motor.
CAUTION
Burns as a result of touching hot surfaces
In operation, the motor enclosure can reach high temperatures, which can cause burns if
touched.
• Do not touch any hot surfaces.
• Allow the motor to cool down before starting any work.
• Use the appropriate personnel protection equipment, e.g. gloves.
– Release the motor connector. Detailed information is provided in Chapter "Notes for
connecting the round connector at the motor".
– Release the motor mounting screws.
– Remove the motor.
– Mount and install the new motor. Detailed information is provided in Chapter "Mounting
instructions (Page 60)."
– Connect the motor plug. Detailed information is provided in Chapter "Notes for
connecting the round connector at the motor".
3. Switch the converter on.
❒
You have replaced the motor.
Maintenance
10.3 Repair, replacing the motor
SIMOTICS S-1FK2 synchronous motors for SINAMICS S120
Operating Instructions, 02/2022, A5E46089564B AD 99

Siemens SIMOTICS S-1FK2 Specifications

General

Brand	Siemens
Model	SIMOTICS S-1FK2
Category	Engine
Language	English