Siemens SIMOTICS S-1FK2 User Manual

5.2 Checklists prior to mounting
Note
Required checks
The checklists below do not purport to be complete. It may be necessary to perform additional
checks and tests in accordance with the situation speci󹪝c to the particular installation site.
• Install the motor as described in the following chapters of the operating instructions.
• Thoroughly familiarize yourself with the safety instructions and observe the checklists below
before starting any work.
Table 5-1 Checklist before installing
Check OK
General checks
Are all necessary components of the con󹪝gured drive available?
Are the ambient conditions in the permissible range?
• Section "Ambient conditions (Page 24)"
Table 5-2 Checklist for checking the mechanical system
Check OK
Check of the mechanical system
Is the motor free of visible damage?
Have the mounting surfaces (e.g. 󹪞ange, shaft) on the customer machine and on the
motor been cleaned?
Are the mounting surfaces free of corrosion?
Do the mounting dimensions (e.g. shaft diameter, shaft length, true run) on the customer
machine meet the speci󹪝cation?
Mounting
5.2 Checklists prior to mounting
SIMOTICS S-1FK2 synchronous motors for SINAMICS S120
Operating Instructions, 02/2022, A5E46089564B AD 59

Siemens SIMOTICS S-1FK2 Specifications

General

Brand	Siemens
Model	SIMOTICS S-1FK2
Category	Engine
Language	English