Siemens SIMOTICS S-1FK2 User Manual

10.2 Inspection and maintenance
10.2.1 Service and inspection intervals
To avoid motor faults, perform maintenance work, inspections and overhauls at regular
intervals.
Note
Inspection if there are faults or unusual conditions
Unusual conditions or faults that represent overstressing of the motor, e.g. overload or short-
circuit, can result in consequential damage to the machine.
Immediately perform an inspection when faults or exceptional conditions occur.
Maintenance measures, inspection/maintenance times intervals
The maintenance intervals depend on the operating conditions.
• Adapt the maintenance intervals to match the local conditions, such as pollution/dirt,
switching frequency, load, etc.
• Perform the following maintenance measures as speci󹪝ed in the table.
NOTICE
Improper maintenance
Service and maintenance must only be performed by properly authorized quali󹪝ed personnel.
Use original Siemens parts only.
Table 10-1 Maintenance measures after operating times or intervals
Machine operation times and intervals Measure
As required Monitor and check the motor for unusual noises,
vibrations and changes
If required or after 25000 operating hours Check radial shaft seal ring and replace if worn.
If required or after 25000 operating hours For 1F☐2☐03 ... 1F☐2☐05 motors:
Replace motor if necessary.
For 1F☐2☐06 ... 1F☐2☐10 motors:
Check motor bearing and replace if necessary.
The maintenance and repair of the motor can be performed in authorized Siemens Service
Centers all over the world.
Contact your personal Siemens representative if you would like to take advantage of this service.
Maintenance
10.2 Inspection and maintenance
SIMOTICS S-1FK2 synchronous motors for SINAMICS S120
96 Operating Instructions, 02/2022, A5E46089564B AD

Siemens SIMOTICS S-1FK2 Specifications

General

Brand	Siemens
Model	SIMOTICS S-1FK2
Category	Engine
Language	English