Siemens SIMOTICS S-1FK2 - Page 6

Operating instructions
Handling instructions with a speci󹪝ed sequence start with the word "Procedure":
The individual handling steps are numbered.
1. Execute the operating instructions in the speci󹪝ed sequence.
❒
The square indicates the end of the operating instruction.
Operating instructions without a speci󹪝ed sequence are identi󹪝ed using a bullet point:
• Execute the operating instructions.
Enumerations
• Enumerations are identi󹪝ed by a bullet point without any additional symbols.
– Enumerations at the second level are hyphenated.
Notes
Notes are shown as follows:
Note
A Note is an important item of information about the product, handling of the product or the
relevant section of the document. Notes provide you with help or further suggestions/ideas.
More information
Information on the following topics is available at:
• Additional links to download documents
• Using documentation online (󹪝nd and search in manuals / information)
More information (https://support.industry.siemens.com/cs/de/en/view/108998034)
If you have any questions regarding the technical documentation (e.g. suggestions,
corrections), please send an e-mail to the following address E-mail
(mailto:docu.motioncontrol@siemens.com).
mySupport
Extensive assistance and more information can be found under the following link:
My Support Links and Tools (https://support.industry.siemens.com/cs/de/en/my)
You can individually compile your personal library, e.g. for your documentation based on
Siemens content, and adapt it for your own machine documentation.
Introduction
SIMOTICS S-1FK2 synchronous motors for SINAMICS S120
4 Operating Instructions, 02/2022, A5E46089564B AD