Preface
Contents of the Commissioning and Hardware Installation Manual
This document is part of the SIMOTION D documentation package.
Scope
The SIMOTION D410‑2 Commissioning and Hardware Installation Manual describes the
commissioning and installation of the SIMOTION D410‑2 DP and SIMOTION D410‑2 DP/PN
control units. A separate
SIMOTION D410
Commissioning Manual is available for the
SIMOTION D410 DP and SIMOTION D410 PN Control Units.
The software configuration is described in this manual based on SIMOTION SCOUT and
SIMATIC STEP 7 Version V5.x.
Information of configuration of the SIMOTION D Control Units in the Engineering Framework
Totally Integrated Automation Portal (SCOUT in the TIA Portal), you will find in the configuration
manual
SIMOTION SCOUT TIA
. The TIA Portal requires at least SIMOTION SCOUT V4.4 and
SIMOTION D4xx‑2 Control Units as of firmware V4.3.
Standards
The SIMOTION system was developed in accordance with ISO 9001 quality guidelines.
Sections in this manual
The following is a description of the purpose and use of this Commissioning and Hardware
Installation Manual:
● Description
This section describes the SIMOTION system and its integration into the information
landscape.
● Installing
This section provides information on the the various installation options for the device.
● Connecting
This section provides information about connecting and cabling the various devices, and
about the communication interfaces.
● Commissioning (hardware)
This section describes how to start up the device and what you must take into account.
● Parameter assignment / addressing
This section describes how to integrate the SIMOTION D410‑2 cm a project and how to
configure the interfaces.
● Commissioning (software)
This section describes how to configure a system and how to test the configured drives and
axes.
SIMOTION D410-2
Commissioning and Hardware Installation Manual, 01/2015 3
To Next Page
Loading...
Need help?
General
