4.11 Routing
Routing describes the cross-network transfer of information from Network x to Network y.
4.11.1
Routing on SIMOTION D
Routing between the different interfaces
SIMOTION D410‑2 supports S7 routing between the following interfaces:
● Between Ethernet interface X127 and PROFIBUS interfaces X21 and X24 (X24 only
available on D410‑2 DP)
● Between Ethernet interface X127 and PROFINET interface X150 (only available on
D410‑2 DP/PN)
● Between PROFINET interface X150 and PROFIBUS interface X21 (only available on
D410‑2 DP/PN)
Each combination of Ethernet interface X127 and PROFINET interface X150 represents a
separate IP subnet.
All ports of the X150 PROFINET interface belong to the same IP subnet.
IP routing from IP subnet to IP subnet is not supported. You can use an external IP router for
this.
Below is a list of the options available for connecting a PG/PC or HMI device to a SIMOTION D
using S7 routing.
Connecting
4.11 Routing
SIMOTION D410-2
74 Commissioning and Hardware Installation Manual, 01/2015
To Next Page
Loading...
Need help?
General
