Commissioning
4.5 Commissioning with STARTER
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
83
● We recommend the following setting in the dialog box "Calculate motor data":
● Set the check mark for "RAM to ROM (save data in the drive)" in order to save your data
in the inverter so that it is not lost when the power fails:
Identifying motor data
If the inverter has still not identified the motor data, alarm A07791 is output. You must
switch-on the motor to identify its data.
CAUTION
Motor data identification for dangerous loads
Secure dangerous plant and system parts before starting the motor data identification, e.g.
by fencing off the dangerous location or lowering a suspended load to the floor.
In STARTER, select the control panel with a double
click.
To Next Page
Loading...
