SINAMICS S120 Cabinet Modules
Engineering Information
SINAMICS Engineering Manual – November 2015
Ó Siemens AG
425/528
Rated power at
400 V
[kW]
Active Line Modules (incl. Active Interface Modules)
Order No.
Supply voltage 380 V – 480 V 3AC (DC Link Voltage 570 V – 720 V)
132 6SL3730-7TE32-1BA3
160 6SL3730-7TE32-6BA3
235 6SL3730-7TE33-8BA3
300 6SL3730-7TE35-0BA3
380 6SL3730-7TE36-1BA3
500 6SL3730-7TE38-4BA3
630 6SL3730-7TE41-0BA3
630 6SL3730-7TE41-0BC3
For parallel connection, mounted on left of LCM
(mirrored mounting)
900 6SL3730-7TE41-4BA3
900 6SL3730-7TE41-4BC3
For parallel connection, mounted on left of LCM
(mirrored mounting)
Rated power at
500 V / 690 V
[kW]
Supply voltage 500 V – 690 V 3AC (DC Link Voltage 750 V – 1035 V)
400 / 630 6SL3730-7TG35-8BA3
580 / 800 6SL3730-7TG37-4BA3
580 / 800 6SL3730-7TG37-4BC3
For parallel connection, mounted on left of LCM
(mirrored mounting)
800 / 1100 6SL3730-7TG41-0BA3
800 / 1100 6SL3730-7TG41-0BC3
For parallel connection, mounted on left of LCM
(mirrored mounting)
1015 / 1400 6SL3730-7TG41-3BA3
1015 / 1400 6SL3730-7TG41-3BC3
For parallel connection, mounted on left of LCM
(mirrored mounting)
Order numbers of the various air-cooled Active Line Modules with associated Active Interface Modules
Please note that parallel connections can only be made with Active Line Modules and the associated Active Interface
modules of exactly the same power rating. The potential for imbalances in current distribution means that current
derating of 5 % must be applied and this must be taken into account when the Modules are dimensioned.
Please also refer to the instructions regarding parallel connections in chapter "Fundamental Principles and System
Description", as well as to the guidance relating to the use of DRIVE-CLiQ cables and their installation in section
"Information about equipment handling / DRIVE-CLiQ wiring".
To Next Page
Loading...
